Emboss a base card

Emboss a 15cm x 15cm black base card

Place the silicone rubber from the starter kit inside the base card.
Stack as follows;- spacer platform, texture plate with paisley side facing upwards, 15x15cm base card with silicone rubber inside, & then finally the impressions pad from the starter kit.
Roll sandwich (stacked layers) through the big shot

The front of your square card should now be embossed

Alternatively emboss a 15x15cm piece of black card & adhere to the front of a base card.

(As the texture plate is slightly smaller than 15cm wide, you will need to trim a small piece from either the top or the bottom of your card.)

Making the card

Cut 2 scallop frames, 1 x pink 1 x white glitter card. Using a hole punch (I used a crop a dile) cut decorative holes in the pink scalloped edge & attach to the white glitter centrepiece.

Cut paisley shapes in black (2), pink (1) & white card (1).

Assemble as shown

Adhere paisley shapes to the centre of the scalloped frame die cut.

(using a craft knife, scrape away the glitter from underneath the paisley shapes, this helps the shape adhere better to glitter card)

Using 3d foam pads, stick the scallop frame to the centre of the black embossed card

Using the Sizzlits Phrase, Happy Birthday! #2 Die, cut the phrase using pink card.

The phrase is joined together. For this card you will need to separate it. You will need to cut away the exclamation mark, as it forms part of the 'H'.

Using Sakura quickie glue pen & tweezers adhere 'Happy' & 'Birthday' centrally above & below the scallop frame.

Products Used in this project